Mechanical and dynamic behavior of fused filament fabrication 3D printed polyethylene terephthalate glycol reinforced with carbon fibersMechanical and dynamic behavior of fused filament fabrication 3D printed polyethylene terephthalate glycol reinforced with carbon fibers Peer-Reviewed Journal Publication Δημοσίευση σε Περιοδικό με Κριτές 2019-05-272018enThe mechanical and dynamic behavior of FFF 3D printed polyethylene terephthalate glycol (PETG) and PETG reinforced with 20% carbon fibers is presented in this paper using several experimental tests. Compression tests, cyclic compression tests, nanoindentation, and modal tests were used as the assessment procedures. The results reveal that the addition of carbon fibers decrease as much as 66% the compressive strain, while increase the modulus and the hardness by around 30 and 27%, respectively. The loss factor and damping as calculated from the cyclic compression and models tests dropped from 17.3 to 15.4% and 13.8 to 12.3%, respectively.http://creativecommons.org/licenses/by/4.0/Polymer-Plastics Technology and Engineering57161715-1725 Mansour Misel-Teontor Μανσουρ Μισελ-Τεοντορ Tsongas Konstantinos Tzetzis Dimitrios Antoniadis Aristomenis Αντωνιαδης Αριστομενης Taylor & Francis Additive manufacturing Carbon fibers Mechanical properties PETG Compression testing Reinforced plastics